View 3D Content; Display Requirements; 3D Sync Terminal Pin Map - Christie CP2215 User Manual

View 3D Content

This section provides information and procedures for setting up and managing 3D presentations.

Display Requirements

To display 3D images you require these items:
• A 3D hardware system:
• Pi-Cell polarizer for display on a screen that has a silver polarization-preserving surface for
use with passive glasses (RealD).
• Rotating polarizing wheel (external) with passive circular polarizing glasses
(MasterImage). Requires a silver screen.
• IR emitter for controlling the left eye/right eye gating (switching) of active glasses
(Xpand).
• Dual projector 3D - passive glasses (circular or linear). Requires a silver screen.
• A 3D connection cable.
• Power supply for your synchronization output device. The 3D sync port can power output devices.

3D Sync Terminal PIN Map

The 3D Sync terminal is a 15-pin D-sub connector (female) located on the projector communications
panel. This table lists the control functions available through the 3D connector.
PIN Signal Name
1 +12V
2 GND
3 GND
4 RS232_RX
5 RS232_TX
6 CONN_3D_MODE+
7 CONN_SYNC+
CP2215 User Manual
020-101225-01 Rev. 1 (01-2014)
Direction
Out Power to 3D device. Maximum 1A (total between both
+12V pins).
/ Ground
/ Ground
In Data to projector from 3D device. 1200 Baud, 8 bits, no
parity. Currently unsupported.
Out Data to projector from 3D device. 1200 Baud, 8 bits, no
parity. Currently unsupported.
Out SYNC from projector. To projector GPO collector.
Compatible with current projector GPIO requirements
and restrictions. (24VDC max, 50mA max)
3D ON = Hi logic level = O/P transistor ON
3D OFF = Low logic level = O/P transistor OFF
Out SYNC from projector. To projector GPO collector.
Compatible with current projector GPIO requirements
and restrictions. (24VDC max, 50mA max)
Description
65