Manual Configuration (Cli); Logging In Through Telnet - Huawei eSpace IAD101H Quick Start Manual

eSpace IAD101H/102H/104H Integrated Access
Device
Quick Start
About This Chapter
You can use the CLI to configure all eSpace Integrated Access Device (IAD) functions.
The chapter describes how to configure about typical scenes and advanced parameters
by using the command line (CLI).In addition, some titles are marked with (SIP) or
(MGCP) to indicate that these service configurations can be implemented over SIP or
MGCP.

4.1 Logging In Through Telnet

The LAN port IP address of the IAD101H/102H/104H is 192.168.100.1 and 1.1.1.1 by
default. You can access the command line interface (CLI) of the IAD through
Telnet.For the IAD104H, serial port is an alternative access. The CLI includes an
interactive Help feature. You can enter a ? to obtain help and press Spacebar to
complete a command name.
Procedure
Step 1
Connect the network port of the PC to of the IAD101H/102H/104H by a network
cable, and then set IP addresses of the PC and IAD in the same network segment. For
example, the default IP address of the IAD is 192.168.100.1, the PC address of the PC
can be set to 192.168.100.2, and the subnet mask to 255.255.255.0. Ensure that you can
ping 192.168.100.1 successfully.
Step 2
Choose Start > Run, and enter "telnet" + a blank space + the actual IP address of the
IAD network port in the Run dialog box. Then click OK.
Step 3
After a connection is established, enter user name root and password admin to log in
to the IAD.
Issue 03 (2012-06-11)
4

Manual Configuration (CLI)

Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 Manual Configuration (CLI)
8