Omron SYSDRIVE MX SERIES User Manual page 33

Mounting the Digital Operator
Place the bottom of the Digital Operator into the open space in the front cover, and push down the
upper side of the Digital Operator.
*Supplemental Information
Before mounting the Digital Operator, be sure to mount the Digital Operator connection plug. To
mount the Digital Operator connection plug, push its tab into the communication connector until it
clicks into place.
Removing and Mounting the Control Circuit Terminal Blocks
Removing the Control Circuit Terminal Blocks
Step (1)
Pull up control circuit terminal block A (Terminals SC, S1 to S6) off the Inverter's front (upper direc-
tion in the figure below) to remove.
Step (2)
Loosen the screws on the both sides of the control circuit terminal block B (Terminals FS, FV, FI,
FC, AM, PC, P2, P1) and pull it up toward the Inverter's bottom (right lower direction in the figure
below) to remove.
2-2 Removing and Mounting Each Part
Control circuit terminal block A
Control circuit terminal block B
2
2-8