Omron SYSDRIVE MX SERIES User Manual page 32

2-2 Removing and Mounting Each Part
(2) Mounting the Terminal Block Cover
Fit the B tabs on the terminal block cover into the main unit housing, and push down the cover from
the upper side until the two A tabs click into place.
2
Removing and Mounting the Digital Operator
Removing the Digital Operator
Pressing the upper tab on the Digital Operator, pull it up to the Inverter's front (upper direction in the
figure below).
*Supplemental Information
When using the communications connector, remove the Digital Operator connection plug. It can be
removed by pulling it up to the Inverter's front (upper direction in the figure below).
2-7