Rdy (Ready) Function - Omron SYSDRIVE MX SERIES User Manual

RDY (Ready) Function

This function prepares for Inverter output to rotate the motor immediately after a RUN command is
input.
Parameter No. Function name
b151 Ready function selection
•When this function is enabled, the RUN (during RUN) LED indicator is always lit, since the Inverter
is in output status even though the motor stops.
•Allocate '52 (operation ready)' to any of multi-function inputs C001 to C006, or set b151 to '01'.
Refer to the table below for the correlation when the multi-function input '52' and b151 are set
simultaneously.
•When this function is enabled, data other than the parameters changeable during operation cannot
be changed.
00
b151 setting
01
<Group C: Multi-function Terminal Function>
The 3G3MX has six multi-function inputs [S1], [S2], [S3], [S4], [S5] and [S6]; two open collector out-
put terminals [P1], [P2]; two relay output terminals [MA] and [MB] (SPDT contact); and one analog
output terminal [AM].
Multi-function Input Selection
• You can allocate the following functions to any of multi-function inputs S1 to S6 (C001 to C006,
C201 to C206) to operate the set function.
•You can select NO- or NC-contact input for each multi-function input S1 to S6.
00: Disabled
01: Enabled
Multi-function input terminal "52"
OFF ON
OFF ON
ON ON
Data Default setting
4-2 Function Mode
Unit

00
4-40
4