Operation; Turning The Ups On; Starting The Ups On Battery; Turning The Ups Off - Eaton Powerware 5125 Installation Manual

Chapter 2

Turning the UPS On

Starting the UPS on Battery

Turning the UPS Off

EATON Powerware

Operation

This section describes:
S
Turning the UPS on and off
S
Starting the UPS on battery
S
Operating modes
After the UPS is connected to utility power, it enters Standby mode. To
turn on the UPS, press and hold the On button for approximately three
μ
seconds. The indicator illuminates solid and the load level indicators
display the percentage of load being applied to the UPS.
NOTE Before using this feature, the UPS must have been powered by utility power at least
once.
To turn on the UPS without using utility power, press and hold the
On button for approximately three seconds. The UPS supplies power
to your equipment and transfers to Battery mode.
To turn off the UPS:
1. Prepare your equipment for shutdown.
2. Press and hold the Off
The UPS transfers to Standby mode (if utility power is available) and
removes power from your equipment.
3. Unplug or remove utility power from the UPS; the UPS shuts down
in five seconds. The load level and battery indicators flash briefly
prior to shutdown.
If you do not unplug or remove utility power from the UPS, it
remains in Standby mode.
®
5125 (9910-E65) UPS Installation Guide for IBM
button for approximately three seconds.
® S
Applications 164201698 Rev 1
27