Performance Series IP Camera Software Configuration Guide
11 Configuring Alarms Settings
Click the Alarm tab to open the alarm configuration interface.
Figure 11-1 Alarm Configuration
Table 11-1 Alarm Configurations
Type
Parameter
Motion Detection
Disk Full
Video Tampering
Alarm
Type
Disk Error
Illegal Access
Scene Changing
External Alarm
84
Function
Check to enable Motion Detection. The system will then trigger an
alarm when motion is detected under the specified circumstances.
Check to enable Disk Full. The system will then trigger an alarm when
the disk (microSD card) is full.
Check to enable Video Tampering. The system will then trigger an
alarm when the camera has been tampered with.
Check to enable Disk Error. The system will then record alarm
information when a microSD card error occurs.
Check to enable Illegal Access. The system will then trigger an
alarm when someone attempts to illegally access the camera.
Check to enable Scene Changing. The system will then trigger an
alarm when the camera scene change event occurs.
Check to enable External Alarm. The alarm is triggered when there is
external alarm input.