Configuring Alarm In And Alarm Out; Configuring Event Settings; Figure 6-3 Alarm In And Alarm Out - Honeywell 60 Series Configuration Manual

Honeywell 60 Series IP Camera Software Configuration Guide
You can configure Tampering Detection as a trigger element to the proactive event
configurations in Video Analytics  Event settings  Trigger. For example, when the
camera is tampered with, camera can be configured to send the pre- and post-event video
clips to a networked storage device. For more information, see

Configuring Alarm In and Alarm Out

Go to Setup Video Analytics  Alarm In and Alarm Out.

Figure 6-3 Alarm In and Alarm Out

Alarm in: Select High or Low to define normal status for the alarm input. Connect an alarm
input from a sensor device to the camera, the camera will report the current signal status. You
may then configure the Normal status (non-trigger status) as High or Low.
Alarm out: Select High or Low to define normal status for the alarm output. Connect an output
line to an external device, the camera will report the current signal status. You may then
configure the Normal status (non-trigger status) as High or Low.
Set up the event source as Alarm In on Event Settings  Trigger. For detailed information,
see Trigger on page 50.

Configuring Event Settings

Go to Setup Video Analytics  Event Settings.
This section describes how to configure the camera to respond to particular situations
(event). A typical application is that when a motion is detected, the camera sends buffered
images to an e-mail address as notifications. Click Help, there is an illustration shown in the
pop-up window explaining that an event can be triggered by many sources, such as motion
detection or external alarm input devices. When an event is triggered, you can specify what
type of action that will be performed. You can configure the camera to send snapshots or
videos to your email address.
48
Trigger on page 50.