Installing the Bubble
Attaching the Bubble to an In-Ceiling Housing
Document 800-05662V1 Rev A
04/11
ACUIX™ PTZ High Speed Analog Dome Installation and Configuration Guide
After you have installed the scan assembly in the housing, and the camera lens
cap has been removed, you can install the bubble.
The installation procedure is slightly different for each type of housing.
To attach the bubble to the housing:
1. Attach the safety cable from the bubble to the bracket inside the housing.
2. Align the three hooks on the bubble with the three mounting posts on the
housing.
3. Turn the bubble clockwise to lock it into the housing.
Figure 2-4
In-Ceiling Housing Bubble Installation
9