Patient Station Buttons - GE Telligence Patient-Staff Communications System Operation Manual

Chapter 4
Patient stations
54
• Linked buttons cannot be used to cancel a lavatory emergency
call. Lavatory emergencies can be canceled only from the
originating lavatory station, or from an associated lavatory
station in the same bathroom.

Patient station buttons

Telligence System patient stations may vary from one room to the
next. Different sets of buttons can be present on patient stations,
depending on patient and staff needs. Standard buttons that may
be present on patient stations are: Code, Emerg, Assist, Privacy, and
Cancel.
Table 5: Descriptions of typical command station buttons
Button Description
Alerts staff about a code blue emergency.
CODE
Alerts staff about an emergency.
EMERG
Sends a request for staff assistance.
ASSIST
Registers your presence in the patient room
PRESENCE
Blocks audio connectons to the patient room
PRIVACY
Clears active calls. Also used to configure equipment inputs,
enter cleaning mode, reset the device, block cord out calls
CANCEL
from being sent, etc.
Custom button kit
Facilities may need to order the Telligence System custom button kit
to rename one or more of the standard buttons shown above.
Alternatively, a system installer may install one or more non-
standard or custom buttons for functions already defined in the
Telligence System. However, if facilities require patient station
buttons for functions not defined in the Telligence System, they must
request them on a totally custom basis.
Notes
• If your facility uses custom labels for patient station buttons,
note the modified button names in the margin.
• Documentation for the use of custom buttons is beyond the
scope of this manual; please contact your supervisor for
instructions on their use.
Telligence Patient-Staff Communication System Operation Manual