Telligence Patient-Staff Communication System Operation Manual
5.
When the call ends, this happens:
The Status light extinguishes.
•
The nurse call row on the Call screen or the reminder row
•
on the Reminders screen disappears.
After speaking with the patient, a staff member may
•
proceed to the patient room.
Using a call cord or bed button to upgrade a call
Upgrading a call placed using a call cord or an electronic bed's
nurse call button requires presence to already be registered in the
patient room (See "Registering staff presence" on page 99.) To
upgrade a call that a patient placed using a call cord or an
electronic bed's nurse call button to more urgent status:
1.
Press the nurse call button on the call cord or bed side-rail
control panel (or squeeze the call cord's actuator) twice in rapid
succession. When you do, this happens:
The call assurance tone sounds at the patient station.
•
Top light sections of associated corridor and zone lights fast
•
flash red.
On 4-section dome lights, the second light sections down
•
show a steady white.
Staff consoles and annunciators show two calls — the staff
•
emergency call and the original call (the latter call clears
when the staff emergency call is canceled).
Staff emergency tones sound at staff consoles and
•
annunciators, and at stations here staff follow is active.
2.
When the staff emergency call is answered at the staff console,
this happens:
All communication between the patient room and the staff
•
console attendant is over the speakerphone on the patient
station.
The Status light on the patient station shows a steady
•
green.
3.
During the call, communication from the patient room can take
place in a normal conversational tone via the speakerphone in
the patient station on the wall.
Note:
If necessary, the staff member can adjust call volume
settings on the staff console or annunciator.
4.
When the call ends, this happens:
The Status light changes from a steady green to a steady
•
red.
Chapter 4
Patient stations
75
Need help?
Do you have a question about the Telligence Patient-Staff Communications System and is the answer not in the manual?
Questions and answers