Patient Station Lights - GE Telligence Patient-Staff Communications System Operation Manual

Telligence Patient-Staff Communication System Operation Manual

Patient station lights

Lights on the front of the station illuminate buttons in dim light.
Other patient station lights indicate different states:
• Each patient station button has an associated status light.
• Call lights show the status of nurse call requests (per bed) from
a station.
• Equip lights show the status of equipment connections.
• Status light shows audio connection, staff follow, presence,
privacy, or error.
The various illuminations of these lights specifically denote the
following:
Individual button lights
A steady red status light indicates that the button was pressed and
that the following actions, specific to each button, have taken place:
• For the Code, Emerg, and Assist button lights, a nurse call was
placed.• For the Privacy button, privacy mode was put into
effect.
• For the Presence button, presence has been established in this
room
• The Cancel light slow flashes when a plug is inserted into the
auxiliary jack to indicate a 5 second configuration mode
• The Cancel light flashes when the Cancel button is pressed, and
held and there are no calls to clear
• A flashing Cancel light indicates that one (or both) of the patient
station cords (for the bed connector, Smart Pillow Speaker, or
call cord/auxiliary input) is out.
Call status light
A steady red Call status light indicates a nurse call has been placed
by:
• A patient using a Smart Pillow Speaker, call cord, or bed button
• A staff member using a patient station button or a button on a
peripheral device (such as a staff emergency station) in the
patient room
• Connected medical equipment (when an alarm condition
occurs)
• A flashing Call status light indicates that one (or both) of the
patient station cords (for the bed connector, Smart Pillow
Speaker, or call cord/auxiliary input) is out.
Chapter 4
Patient stations
55