Displaying The Screen You Need - GE Telligence Patient-Staff Communications System Operation Manual

Displaying the screen you need

Telligence Patient-Staff Communication System Operation Manual
To change the screen displayed on the staff console or annunciator,
touch the corresponding screen selection tab. Screen selection tabs
are continuously displayed at the bottom of each screen.
Figure 11: Screen selection tabs
The following table shows which tab to select in order to display the
screen you need.
Table 4: Screen selection tabs corresponding to specific tabs
To perform this task
Adjust alert tone volume
Adjust the call volume
Answer a call
Answer a reminder
Clean the touch screen
Clear a reminder (normal priority)
Configure call priorities for a room or
bed
Hang up or cancel a call
Place a call
Recalibrate the touch screen
Set a reminder
Turn off alert tones
Upgrade a call to a higher priority
Using staff consoles and annunciators
Select this tab
Audio tab
Audio tab
Calls tab
Reminders tab
Admin tab
Reminder tab
Room list tab
Audio tab
Room List tab
Admin tab
Audio tab
Call tab, Reminders tab, Room List
tab
Audio tab
Chapter 3
23