Maintenance Mode - Epson Stylus PRO 7500 Service Manual

EPSON Stylus Pro 7500

5.2.4 Maintenance Mode

The operation described here is a special function for the sake of
service support and public disclosure to the end user is prohibited.
o
Starting Method
While pressing the following panel button, turn the power switch On to start the
Maintenance Mode.
n
Pause button
o
Operation Method:
(1) Pressing the Paper Source button once causes you to enter the setting item
selection mode. At this time, the item at the top of the setting menu is displayed, with
the display format as follows.
[Setting Item] = [Current Setting Value] *
The "*" at the end shows that the value is the current setting value.
(2) Each time the Paper Source button is pressed, the next setting item in the sequence
is displayed in the format [Setting Item] = [Current Setting Value] *, with the "*" at the
end showing that the value is the current setting value.
(3) With a setting item displayed, each time the Paper Feed + button or Paper Feed –
button is pressed, the values that can be set are displayed in sequence with the format
[Setting Item] = [Current Setting Value] *. The "*" at the end is displayed only when
the displayed setting value is the current setting value.
If the Paper Feed – button is pressed, the items are displayed in reverse order. If you
continue to press the Paper Feed + button or the Paper Feed – button a predetermined
length of time, the setting values change in sequence at a predetermined interval, either
in forward sequence or reverse sequence. If you continue to press the button, after a
predetermined period of time, the display interval for the consecutive display values
will be speeded up.
Adjustment
(4) If the "Enter" button is pressed, the currently set value is set as the current setting
value and registered. Execution of the items accompanying this operation is also
started. However, nothing happens in the case of those items with a "*" displayed after
them already.
(5) If the SelecType button is pressed while in the Setting Item selection mode, the
printer returns to the maintenance mode display.
o
End Method:
(1) to change the panel display language selection, carry out Reset after setting, then
the printer will automatically change to the ready to print state.
(2) Turn the power OFF, then ON.
o
The following Maintenance Mode Setting Item List will be displayed.
Table 5-14. Maintenance Mode Setting Item List
Item
HEX Dump Print
Panel display language selection
(for Domestic)
M/W Mode Setting
*1:During HEX dump mode execution, the message "HEX MODE" is displayed.
Adjustment Steps
Revision A
Panel Display Setting Value
HEX DUMP Print *1
ENGLISH, FRENCH,
LANGUAGE ITALIAN, GERMAN,
SPANISH, PORTUGUE
MW7 A/B
214