Adj Top & Bottom - Epson Stylus PRO 7500 Service Manual

EPSON Stylus Pro 7500
ADJ TOP & BOTTOM
This function sets the distances between the P FRONT sensor and heads, cutter and heads,
as well as the P EDGE sensor and heads. You can also use this function to adjust the top,
bottom, and side margins.
1. Make sure "Adj. Top & Bottom" appears, and press the Enter button.
2. The printer prints a check pattern (lines) and cuts off the paper at a fixed distance.
3. After the printing operation is finished, measure the top, bottom, and right (HP) side
margins using a ruler. Press the item select (Paper Feed) +/- buttons to enter each of
these measurements in 0.1mm increments.
4. After entering the measurements, press the SelecType or Item button until "Bottom
Length xx.xmm" appears, and then press the Enter button.
Figure 5-35. Margin Adjustment Operation
Adjustment
Figure 5-36. Measuring Sections/Margin Adjustment Pattern
Adjustment Item:
Top Distance P_FRONT sensor position
Bottom DistanceCutter position
Side Margin Print start position
Adjustment Steps
Revision A
206