Affixing Labels - Epson Stylus PRO 7500 Service Manual

EPSON Stylus Pro 7500
51. Put the front end of the ink supply tube in the damper's connection fitting, then tighten
the hex nut with the exclusive torque wrench. If excessive tightening torque is used, it
will cause the O-ring to be deformed, resulting in ink leaking and air bubbles getting
mixed into the ink.
Figure 4-132. Tightening the Hex Nuts
When you are connecting the ink supply tubes to the dampers using
the hex nuts, the exclusive tool #F760 should be used.
52. Assemble the damper holder and CR cover.
53. Install the right side cover.
Disassembly & Assembly

AFFIXING LABELS

1. Affix the following labels in the specified locations.
n
EPSON COLOR FAST Label
Affix this label on the bottom of the right side cover panel. (In the EPSON
COLOR Fast label position)
n
Manual Cutter Cutting Position Labels
Vertical Position:
Horizontal Position:
Figure 4-133. Label Affixing Position
Disassembly Flow
Align the scissors cutting line on the label with a position 12.7
cm down from the bottom of the paper guide L sub-platen.
Align the label's left edge with a position 3 cm from the right
side frame edge.
EPSON COLOR FAST
12.7 cm
(down from the bottom of the
paper guide L sub-platen to the
scissors cutting line position)
3cm
Revision A
161