Epson Stylus PRO 7500 Service Manual page 227

EPSON Stylus Pro 7500
Plate on tool
Paper Guide L
Figure 5-52. Moving the CR Unit
4. At the position where the top of the cutter holder and the bottom side of the plate on the
tool touch each other, fasten the paper guide L with the three installation screws.
5. Loosen the three cutter solenoid installation screws, then push the cutter holder until its
front end reaches the tool, then tighten the 3 installation screws. See Fig. 5-52 for the
positions of the installation screws.
tool Plate Bottom
Figure 5-53. Adjustment 1
Adjustment
Cutter Solenoid Installation
Screws
Cutter Solenoid Notch
Cutter Holder Top
Adjustment Steps
6. Set the exclusive tool #F763 in the row of holes to the left in the center level of the
paper guide L's sub-platen, then adjust in the same way as in Steps 3 ~ 5 above, then
confirm the results.
Exclusive tool #F763
Figure 5-54. Adjustment 2
Revision A
Cutter Solenoid Installation
Screws
227