Pigment Ink Initial Charge; Uploading Pigment Ink Firmware - Epson Stylus PRO 7500 Service Manual

EPSON Stylus Pro 7500

PIGMENT INK INITIAL CHARGE

1. Take the 6 pigment ink cartridges from the conversion kit and set them in the I/H
holders.
2. Insert the AC cable in the outlet.
3. When the printer's power switch is turned on, the initial filling sequence will start
automatically. Approximately 5 minutes is necessary to complete this sequence. The
main initial filling flag starts based on the flag set on Page147.
Disassembly & Assembly

UPLOADING PIGMENT INK FIRMWARE

1. The printer's firmware should be updated to the firmware for pigment ink using the
exclusively stipulated PC card or via the parallel interface cable.
n
Whichever method is used, a PC card or the parallel interface
cable, if the power is turned off during the firmware update
process, this procedure should be repeated from the beginning.
n
If you are updating the firmware via a PC card, the following PC
card should be used.
Tool No. : #F727 Flash Memory
ASP Code: 1050073
n
If you are updating the firmware via a PC card, it should be used
after writing data using the following utility.
ADTEC System Science Card Utility 97
n
If you are writing firmware via the parallel interface cable, it
should not be used in the ECP mode. The compatible mode
should be used.
n
The firmware file extension will differ as follows depending on
the means used to write the firmware, so it should be used so as to
be incorporated correctly.
• Via the PC: L0XX0X. ipl
• Via a PC Card: L0XX0X. rom
Note): The "X" differs depending on the version.
o
Uploading via the Parallel Interface
1. Make sure the BIOS setting of the PC you are using is not the ECP mode setting. This
operation runs only in the compatible mode.
2. Start the firmware upload mode while pressing the following buttons. In this mode, the
yellow ink LED will light up and "Data Transfer" will be displayed in the LCD.
Disassembly Flow
Revision A
162