Epson Stylus PRO 7500 Service Manual page 123

EPSON Stylus Pro 7500
Key which engages the
cutter holder with the
carriage
Figure 4-47. Cutter Holder Assembly (Rear)
After installing the cutter holder assembly, the following adjustment
should be done.
n
The cutter positioning adjustment should be done. Refer to
Page226.
Disassembly & Assembly
4.2.3.5.1 Removing the Cutter Solenoid
1. Remove the cutter housing as described in "Removing the Cutter Housing" on
page 122.
2. Release the engagement between the cutter cap and the CR lock kicker, then remove
the cutter cap + cutter solenoid iron core and cutter solenoid spring.
NOTE: During assembly, the cutter cap and the CR lock kicker should be
engaged. (If they are not engaged, the carriage cannot be moved from the
home position to the left when the power switch is turned on.)
3. Take out the 2 screws (CP(W) M3 x 6) holding the cutter solenoid, then remove the
cutter solenoid while pushing out the cutter holder assembly from the bottom with the
shaft of a (+) screwdriver, etc.
push cutter
solenoid
screws(M3x6)
cutter solenoid
Figure 4-48. Cutter Solenoid Removal
Disassembly Flow
Revision A
CR lock kicker
cutter cap, cutter
solenoid iron core,
cutter solenoid spring
123