Epson Stylus PRO 7500 Service Manual page 151

EPSON Stylus Pro 7500
10. Take out the 2 waste fluid tubes (Color: White) set in the waste ink pads with deep
caution, then wrap the front ends in a piece of cloth or in soft paper, etc.
Also, take the flushing tubes (Color: Semitransparent) from the flushing tube clamp on
the waste ink pads with extreme care, then wrap their front ends with a piece of cloth or
tissue, etc. as with the waste fluid tubes.
Waste Fluid Tube
Figure 4-102. Taking out each type of tube.
11. Release the two hooks used to fasten the waste ink pad boxes from the printer's bottom
surface, then slide the waste ink boxes toward the printer's front.
Printer Bottom
Center
Waste Ink Pad Box
Figure 4-103. Removing the Waste Ink Pad Boxes
Disassembly & Assembly
Flushing Tube
Printer Right
Bottom Surface
fastening Hooks
12. Release the hooks holding the waste fluid tube holders at the left and right ends of the
waste ink pad boxes, then remove the waste fluid tube holder together with the tubes.
Figure 4-104. Removing the Waste Fluid Tube Holder and Tubes
13. Take out new waste ink pads from the conversion kit and replace the old pads that are
in the waste ink pad boxes.
Disassembly Flow
Waste Fluid Tube
Holder Fastening
Hooks
Waste Fluid Tube
Holder
Revision A
151