Epson Stylus PRO 7500 Service Manual page 139

EPSON Stylus Pro 7500
4.2.3.11 Removing the HEAD_SLIDE Sensor Assembly
1. Remove the R Side Cover as described in "R Side Cover Removal" on page 103.
2. Remove the Rear Cover as described in "Rear Cover Removal" on page 106.
3. Disconnect the harness for the HEAD_SLIDE Sensor Assembly from its connector on
the main board and take the harness out from the hole in the R Side Frame.
4. Push the carriage lock using your finger to unlock the carriage and move the carriage
from the home position to the left.
5. Remove the one (CP(W) M3x6) screw securing the HEAD_SLIDE Sensor Assembly
and remove the HEAD_SLIDE Sensor Assembly.
6. Release the harness for the HEAD_SLIDE Sensor Assembly from the four cable
clamps on the Maintenance Assembly and CR Rail Assembly.
clamp 2/4
clamp 1/4
Head-slide sensor
assembly
Figure 4-84. Removing the HEAD_SLIDE Sensor Assembly-1
Disassembly & Assembly
screw(M3x6)
Disassembly Flow
sensor harness
clamp
(on CR rail)
clamp
(on maintenance base)
Figure 4-85. Removing the HEAD_SLIDE Sensor Assembly-2
Revision A
139