EPSON Stylus Pro 7500
4.
While spreading the waste ink holder mounting plate hooks toward the outside,
disconnect the waste ink holder mounting plate from the waste ink holders.
5.
Remove the waste ink pads from the waste ink holders.
6.
Place new waste ink pads (Left: x 4; Right: x 6) in the waste ink holder, then install the
waste ink holder mounting plate. Then assemble the printer, following the disassembly
sequence in reverse order.
NOTE1:When setting each tube in the waste ink holder mounting plate, the tubes
should be set in the waste ink holder mounting plate hooks so that their
ends are positioned about 20 mm higher than the bottom of the waste ink
holder's bottom. (If they are not set correctly, ink discharge may not be
accomplished correctly.
NOTE2:All the ink tubes should be installed so that there is no undue bending or
crushing.
Waste ink holder
Waste ink pads (x4)
mountig plate
Figure 4-34. Waste Ink Holder Disassembly
Disassembly & Assembly
Waste ink pads (x6)
hook
n
During waste ink pad replacement, only the pads are replaced, so
plastic bags, etc. should be prepared in advance and these should
be used for recovering the replaced ink pads.
Disassembly Flow
Revision A
116