Backing Up Parameters From Main Board To Pc Card; Downloading Parameters From Pc Card To New Board - Epson Stylus PRO 7500 Service Manual

EPSON Stylus Pro 7500

BACKING UP PARAMETERS FROM MAIN BOARD TO PC CARD

1. Remove the access cover (two screws) from the rear of the printer, and make sure the
Control Panel unit is attached.
NOTE: The operation panel unit should be connected.
2. Insert the PC card (top facing the outside of the printer) into the PC card slot connector
(CN20) on the Main Board, and then turn on the printer.
NOTE: It should be set so that the memory card surface is facing the printer's
outside.
3. Make sure the following message appears on the LCD, and wait for the procedure to
begin.
Wait:F->M Push:M->F
4. The backup procedure starts about 15 seconds after the message appears.
Flash -> Mcard
Do not touch the Control Panel buttons at this point. Doing so causes
the PC card to download its data to the Main Board's Flash memory
instead of backing up the data in Flash memory. In other words, this
clears the parameters!
5. When the backup procedure is finished, the following message appears.
End [Success]
6. After making sure the printer is finished, turn off the printer and remove the PC card.
Adjustment

DOWNLOADING PARAMETERS FROM PC CARD TO NEW BOARD

1. Make sure the access cover is removed from the top of the Upper Paper Guide, and
make sure the Control Panel is attached.
NOTE: The operation panel unit should be connected.
2. Insert the PC card containing the backup data (top facing the outside of the printer) into
the PC card slot connector on the Main Board, and turn on the printer.
NOTE: It should be set so that the memory card surface is facing the printer's
outside.
3. Make sure the following message appears on the LCD.
4. Press any button on the Control Panel to start the download procedure.
You need to press one of the Control Panel buttons within 15 seconds;
otherwise the printer will start the backup procedure instead of the
download procedure. This overwrites parameter data stored in the PC
card with data stored in the Main Board Flash memory.
5. When the download procedure is finished, the following message appears.
6. After making sure the printer is finished, turn off the printer and remove the PC card.
7. Replace the access cover on the rear of the printer.
Adjustment Steps
Wait:F->M Push:M->F
Mcard -> Flash
End [Success]
Revision A
175