Epson Stylus PRO 7500 Service Manual page 159

EPSON Stylus Pro 7500
38. Open the I/H cover and loosen the 2 screws (CBS M3 x 10) holding the I/H holder,
then remove the I/H holder from each I/H cover.
CBS M3 x 6 Screw
Figure 4-126. Removing the I/H Cover
39. Remove the I/H cover from the I/H holder, then assemble the I/H cover taken from the
conversion kit on the I/H holder.
Confirm that the 6 ink cartridge No. labels are affixed to the I/H
holder.
The ink cartridge No. labels are affixed to the I/H holders at the
conversion kit assembly plant.
Figure 4-127. Ink Cartridge No. Labels
Disassembly & Assembly
40. Assemble the I/H holder with 2 screws (CBS M3 x 10).
41. Assemble the left side frame on the printer mechanism.
42. Confirm that the CR unit is outside the capping position, then loosen the 2 CR cover
installation screws (CP(W) M3 x 6) and remove the CR cover.
Figure 4-128. Removing the CR Cover
43. Take out the 1 screw (CP(W) M3 x 6) holding the damper holder. Release the fastening
hook on the damper holder's left side.
Damper Holder Hook
Figure 4-129. Removing the Damper Holder
Disassembly Flow
Revision A
CP(W) M3 x 6 Screws
Damper Holder
CP(W) M3 x 6
Screw
159