Adj Check Skew - Epson Stylus PRO 7500 Service Manual

EPSON Stylus Pro 7500

ADJ CHECK SKEW

When the band turns a predetermined amount (during printing), the printer detects the paper
edge using the P_EDGE sensor.
1. Make sure "Adj: Check Skew" appears on the LCD and press the Enter button.
2. If the paper is not loaded correctly, "Reload Paper" appears indicating you need to
properly load the paper. If the paper is set correctly, the printer initializes the paper.
3. After paper is loaded and initialized, "Check Skew
Feed + and Paper Feed - buttons to adjust the paper-skew detection distance, then press
Enter to begin the skew check.
4. After the skew is correctly detected, "Skew Result: xxxx" appears. Press Enter to
proceed to the next menu item, or press Pause to return to the beginning; "Adj: Check
Skew" appears on the LCD.
5. Proceed to the following adjustment items by pressing the Enter button. (If the "Pause"
button is pressed, the program will return to the "Adjustment" Paper skew check" item
again without updating the parameters).
Figure 5-15. Skew Check Operation
Adjustment
1.0m" appears. Use the Paper
Adjustment Steps
NOTE: If the paper check LED blinks or stays lighted up, a paper sensor error
has occurred. After releasing the paper set lever once, perform this
adjustment again.)
Revision A
194