Epson Stylus PRO 7500 Service Manual page 109

EPSON Stylus Pro 7500
4.2.1.9 Front Cover Removal
1. Open the Front Cover.
2. Push in the two hooks to the left of the cover and remove the front shaft cover.
spring pin
front cover
support
Figure 4-22. Front Cover Removal 1/3
3. On the right, remove the E-ring and the spring.
front cover spring R
front cover fulcrum pin
Figure 4-23. Front Cover Removal 2/3
Disassembly & Assembly
E-ring
front cover spring L
hooks
spring pin
E-ring
4. Remove the 2 plastic stop wheels E5, and remove the front cover fulcrum pin L on the
left outside. (At this time, the front cover and front cover spring L can be removed
from the front cover fulcrum pin.)
fromt cover fulcrum
pin L
Figure 4-24. Removing the Front Cover 3/3
5. Remove the front cover spring R and front cover from the front cover fulcrum pin R,
then remove each respective part.
The front cover springs R/L should be installed correctly.
The cover switch holder installation position should be checked so that
the cover sensor assembly is linked to the front cover when it opens
and closes.
n
5.2.5.4 Cover Sensor Assembly Mounting Position
Adjustment. Refer to Page223.
Disassembly Flow
Revision A
front cover
plastic stop wheels
E5
109