Test Print Menu - Epson Stylus PRO 7500 Service Manual

EPSON Stylus Pro 7500

1.6.2 Test Print Menu

In the test print menu, the test printing shown in the following table can be done. Each test
is set by operating the following panel buttons. When each test printing operation is
completed, the printer returns automatically to the Pause state.
o
Test print menu selection: See the panel setting menu procedure.
o
Test Print item selection: "Paper Source" Button
Set print execution: "Enter" button
A list of the setting items in the printer setting menu is shown below.
Table 1-25. Printer Test Print Menu Setting Item List
Display Set Value
NOZZLE CHECK PRINT * 1
STATUS CHECK Print * 2
*1: By running this mode, the head (all 6 colors) nozzle check pattern is printed and the
firmware version and waste ink counter (remainder [%]) are printed.
Firmware Version)
Waste ink counter, xx: Remainder [%])
Figure 1-8. Nozzle Check
*2: The status sheet is printed out with the following specifications.
Product Description
Content
Prints the nozzle check pattern.
Prints the printer setting contents.
Panel Setting Menu
o
Output paper size: A4
o
Font used: Internal font (alphanumeric characters)
o
Output Contents:
• Printer ID (= Head ID XX - XX - XX - XX - XX - XX)
In XX, the parameters IwAB-A ~ IwEF-B stored in NVRAM are printed out
in decimal numbers.
The order, from the left to right, is K - C - M - Y - Lc - Lm.
• Type B Interface Connection Condition
When installed ...... Installed
When not installed ...... None
• List of Panel Settings (including the printer status)
See the figure below.
Figure 1-9. Status Sheet
Revision A
40