www.gateway.com
Filling empty drive bays
Installing the optional diskette drive
The diskette drive is not hot-swappable.
Before installing or removing the drive,
make sure that power is turned off and
the power cord(s) is unplugged.
Make sure that the tray's release lever is open, then slide the new drive
4
fully into the empty hot-swap drive bay and push the lever back into place.
Empty drive bays in the server must be filled by drive trays with dummy hard
drives installed. With the bezel removed, install the appropriate carrier, then
replace the bezel by snapping it into place on the front of the server. Dummy
hard drives are included with your server and are installed in unused drive bays.
To install the optional diskette drive:
Caution
Follow the instructions in
1
page
28. Make sure that you turn off the server, then unplug the power
cord(s) and all other cables connected to the server.
Follow the instructions in
2
Unlock the bezel (if necessary) and remove it by pulling it from the chassis.
3
Push the diskette drive bay cover (EMI shield) (1) in from the front of the
4
server
Installing and removing drives
"Preventing static electricity discharge" on
"Opening the server case" on page
29.
35