Show Platform Stack Manager - Cisco Catalyst 3750-X Command Reference Manual

Appendix C Catalyst 3750-X and 3560-X Show Platform Commands

show platform stack manager

Use the show platform stack manager privileged EXEC command to display platform-dependent
switch-stack information.
Note This command is supported only on Catalyst 3750-X switches.
Syntax Description all
counters
trace [sdp [reverse]]
trace [state [reverse]]
Command Modes Privileged EXEC
Command History Release
12.2(53)SE2
Usage Guidelines Use this command only when you are working directly with your technical support representative while
troubleshooting a problem. Do not use this command unless your technical support representative asks
you to do so.
The summary information about the switch stack shows these states:
•
•
•
•
OL-29704-01
show platform stack manager {all | counters | trace [sdp [reverse] | state [reverse]]}
Display all information for the entire switch stack.
Display the stack manager counters.
Display trace information. The keywords have these meanings:
•
•
Display trace information. The keywords have these meanings:
•
•
Modification
This command was introduced.
Waiting—A switch is booting up and waiting for communication from other switches in the stack.
The switch has not yet determined whether or not it is a stack master.
Stack members not participating in a stack master election remain in the waiting state until the stack
master is elected and ready.
Initializing—A switch has determined whether its stack master status. If it is not the stack master,
it is receiving its system- and interface-level configuration from the stack master and loading it.
Ready—The member has completed loading the system- and interface-level configurations and can
forward traffic.
Master Re-Init—The state immediately after a master re-election and a different member is elected
master. The new master is re-initializing its configuration. This state applies only to the new master.
sdp—(Optional) Display Stack Discovery Protocol (SDP) information.
reverse—(Optional) Display trace information in reverse chronological
order (from recent to older chronological sequence).
state—(Optional) Display stack state machine information.
reverse—(Optional) Display trace information in reverse chronological
order (from recent to older chronological sequence).
Catalyst 3750-X and 3560-X Switch Command Reference
show platform stack manager
C-39