Connect To An Ethernet Network; How To Connect To Virtual Private Networks - Intermec CN51 User Manual

Chapter 6 — Configure the Computer

Connect to an Ethernet Network

How to Connect to Virtual Private Networks

102
3 Tap and then tap Advanced. The Advanced Wi-Fi menu appears.
4 Clear the Network notification check box to disable notifications.
To connect the conputer to an Ethernet network, you need an Ethernet
dock.
1 Make sure the dock is connected to your Ethernet network.
2 Place the computer in the dock.
3 Start the Settings app and make sure Ethernet is enabled (Ethernet
is enabled by default).
To enable Ethernet, slide the Ethernet switch on. When the switch
turns blue, Ethernet is enabled.
4 Tap Ethernet. The Ethernet list shows the name of the current
Ethernet connection. By default, the computer assumes a DHCP
connection, and that your network has assigned an IP address
automatically. If DHCP is working, the Ethernet dock should
indicate that communication with the network is occurring.
5 (Optional) To assign a static IP address, tap the connection name
(for example, eth0). The IP settings dialog box appears.
a Tap DHCP and then select Static from the list.
b Enter the required network information and then tap Apply.
The computer supports connecting to virtual private networks
(VPNs). This section describes how to add and connect to VPNs.
To configure VPN access, you must obtain details from your network
administrator. You view and change VPN settings in the Settings app.
Note: Before you can access VPNs, you must set a screen lock method.
CN51 Mobile Computer User Manual