Codabar Settings - Intermec CN51 User Manual

Chapter 3 — Use the Scanner
46

Codabar Settings

This section lists all configurable settings for decoding the Codabar
symbology.
Codabar Settings and Descriptions
Setting
Start/Stop transmit
CLSI library system
Verify check digit
Transmit check digit
Concatentation
Concatentation mode Sets the concatenation mode. Options include:
User defined
symbology ID
Code mark
Description
Enables or disables a special bar code character that
provides the scanner with start and stop reading
instructions as well as a scanning direction
indicator. Options include:
•
Disable (default)
•
a,b,c,d
•
A,B,C,D
•
a,b,c,d/t,n,*,e
•
DC1,DC2,DC3,DC4
Enables or disables the CLSI library system. Default
is disabled.
Enables or disables the optional check digit for a
higher level of security. Default is disabled.
Enables or disables transmission of the check digit
as part of the bar code data. Default is disabled.
Enables or disables concatentation of Codabar bar
codes. Options include:
•
Disable (default)
•
Transmit concatenation only: Scanner sends only
concatenated bar code data.
•
Transmit concatenation or single: Scanner sends
all bar code data.
•
No restriction (default)
•
2nd code = 1st code start
•
ABC
Sets the symbology ID for Codabar. Range is 1 to 4
ASCII characters. \xFF is not supported.
Default is B7.
A one-character code mark that serves as an
identifier for BPO. Default is D.
CN51 Mobile Computer User Manual