Using Static Wep Security; Configuring Static Wep Security With Funk Security - Intermec CK31 User Manual

Chapter 2 — Configuring the CK31
6 For Prompt for Credentials, choose Enter credentials now.
7 Select User name, type your user name, and then press
Enter.
8 Select User Password, type a user password, and then press
Enter.
9 Exit Intermec Settings.

Using Static WEP Security

The CK31 uses the Wired Equivalent Privacy (WEP) protocol
to add security to your wireless network based on the 802.11b
standard.
To use WEP security, you need:
• a CK31 handheld computer with an 802.11b/g radio.
• an access point with an 802.11b/g radio.

Configuring Static WEP Security With Funk Security

1 Make sure you have selected Funk as your security choice.
2 Make sure you have configured the communications and
radio parameters on your CK31.
3 Open Intermec Settings.
4 Choose Communications > 802.11 Radio > Funk Security
> Profile.
5 For Association, choose Open and then press Enter.
6 For Encryption, choose WEP and then press Enter.
7 For 8021x, choose None and then press Enter.
8 Define a value for the keys you want to use. You can define
up to four keys (Key 1 through Key 4).
Enter an ASCII key or a hex key that is either 5 bytes or 13
bytes long depending on the capability of the radio. Set a 5-
byte value for 64-bit WEP or a 13-byte value for 128-bit
WEP. Hex keys must be preceded by 0x and contain 5 or 13
hex pairs.
9 For Transmit key, choose the key you want to use for
transmitting data.
58 CK31 Handheld Computer User's Manual