Configuring 802.11B/G Radio Communications - Intermec CK30 User Manual

Configuring 802.11b/g Radio Communications

Make sure all components with antennas are at least 30 cm
(1 ft) apart when power is applied. Failure to comply could
result in equipment damage.
Attention: Assurez-vous que la distance entre tous les
éléments avec antennes soit d'au moins 30 centimètres (un
pied) avant de faire la connexion avec l'alimentation
électrique, faute de quoi vous risquez d'endommager votre
installation.
The wireless CK30 has an internal 802.11b/g radio to transfer
data using wireless communications. This section of the manual
assumes that you have already set up your wireless
communications network including your access points. If you
are using a UDP Plus network, you also need to have your
Intermec Gateway or DCS 30X communicating with a host
computer.
Your CK30 supports these network protocols:
• TCP/IP
• UDP Plus
The next sections explain the parameters you need to configure
for the CK30 to work in your wireless network.
Configuring the Network Parameters for a TCP/IP Network
In a TCP/IP network, the CK30 communicates with a host
computer directly using TCP/IP. The access point acts as a
bridge to allow communications between the wired network and
the wireless network.
CK30 Handheld Computer User's Manual
Chapter 2 — Configuring the CK30
41