Authentication/Security Settings; System Administrator Settings - Dell C5765dn User Manual

Authentication/Security Settings

In [Authentication/Security Settings], you can configure the registration and authentication
of a user and security settings.
For more information about the feature, refer to "Authentication and Accounting Features" (P.477).
The following shows the reference section for each setting.

System Administrator Settings ............................................................................................... 407

Authentication......................................................................................................................... 408
Job Status Default ................................................................................................................... 415
Overwrite Hard Disk ............................................................................................................... 415
1
On the [Tools] screen, select [Authentication/Security Settings].
For the method of displaying the [Tools] screen, refer to "System Settings Procedure" (P.280).
2
Select an item to set or change.
System Administrator Settings
In [System Administrator Settings], you can set the system administrator ID and passcode.
We recommend setting the system administrator ID and passcode to prevent unauthorized
setting changes and ensure security.
System Administrator's Login ID
Set the system administrator's user ID. Enter the ID from 1 to 32 single-byte characters.
Note
1
Select [System Administrator's Login ID].
2
Select [On].
3
Select [Keyboard].
4
Enter the system administrator's ID with up to
32 characters, and then select [Save].
5
Repeat steps 3 and 4 to re-enter the same
system administrator's ID in [Re-enter System
Administrator's Login ID].
6
Select [Save].
7
A confirmation window appears. Select [Yes] to confirm your entry.
System Administrator's Passcode
Set the passcode for the System Administrator.
Setting a passcode is strongly recommended to enhance security.
Note
The system administrator's passcode set here is used when [Passcode Entry from Control
Panel] is set to [On] under [Authentication/Security Settings] > [Passcode Policy].
Set the passcode after setting the system administrator's user ID. You can set the passcode
from 4 to 12 characters.
For more information about Passcode Entry from Control Panel, refer to "Passcode Policy" (P.412).
• The default of the system administrator's user ID is "admin".
• The default of the system administrator's passcode is "1111".
Authentication/Security Settings
407