Installation When Using Netware; Step 1 Preparations; Step 2 Configuration On The Machine - Dell C5765dn User Manual

17 Printer Environment Settings

Installation When Using NetWare

This section describes how to install the machine using Netware.
The following shows the reference section for each procedure.

Step 1 Preparations ..................................................................................................................434

Step 2 Configuration on the Machine ....................................................................................434

Step 3 Configuration on the Computer .................................................................................435
Dell Printer Configuration Web Tool Setting Items.............................................................436
Step 1 Preparations
The following items are required to set up the machine to use NetWare.
• NetWare server
• TCP/IP or IPX/SPX network environment
• The Driver CD Kit (provided with the machine)
Step 2 Configuration on the Machine
The following describes the configuration procedures to use NetWare on the machine.
Note
For the items that can be configured using Dell Printer Configuration Web Tool, refer to "Dell Printer
Configuration Web Tool Setting Items" (P.436).
Using IPX/SPX
1
Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator's user ID with the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator's passcode,
and select [Enter].
Note
3) Select [Tools] on the [Home] screen.
2
Enable the NetWare port.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [NetWare], and then select [Change Settings].
4) Select [Port Status], and then select [Change Settings].
5) Select [Enabled], and then select [Save].
3
Select [Close] repeatedly until the [Tools] screen is displayed.
4
Select [Close].
Note
434
• You can configure the settings using Dell Printer Configuration Web Tool.
• The default user ID is "admin".
• The default passcode is "1111".
• Rebooting the machine may be required depending on the settings. When a message displayed on the
screen, follow the message and reboot the machine.