Dell C5765dn User Manual page 325

Auto Eject Time
Configure the time that the data so far received by the machine will automatically be printed
since data is no longer sent to the printer.
You can enter a time between 5 and 1275 seconds in 5 seconds increments.
Adobe Communication Protocol
• Standard
Select this when the output protocol of the print driver is in the ASCII format.
• Binary
Select this when the output protocol of the print driver is in the BCP format.
• TBCP
Select this when the output protocol of the print driver is in the TBCP format.
• RAW
Select this when the output protocol of the print driver is in the ASCII or binary format.
The data is printed without being controlled by the Adobe communication protocol.
PostScript Wait Timeout
The machine automatically terminates a connection when the machine does not receive data
for a certain period of time. When data is being printed with [RAW] is selected for [Adobe
Communication Protocol], select [Disabled] if you want to use the time period set in [Auto
Eject Time] or select [Enabled] if you want to use the timeout period of PostScript.
LPD
Port Status
Select [Enabled] to use LPD.
Port Number
Enter a port number for LPD from 1 to 65535.
The default value is 515.
Note
Maximum Number of Sessions
Enter the maximum number of client sessions using LPD. You can enter a number from 1
to 10 in 1 session increments.
The default value is 5.
NetWare
Port Status
Select [Enabled] to use NetWare
SMB
Port Status
Select [Enabled] to use SMB when you use the Scan to PC (SMB) service or share the
machine on the network.
• Do not use the numbers assigned to the other ports.
®
.
Connectivity & Network Setup
325