The Fx Return Parameter View Screen - Roland VS-2000 Owner's Manual

•
•
•
Each Aux and FX bus can receive signals pre- or post-fader, and can be linked to its
odd/even partner. When you select an AUX/FX send control's send status parameter,
ENTER/YES flashes—press ENTER/YES to configure the Aux or FX bus as described
on Page 206.

The FX Return Parameter View Screen

The FX return channels' Parameter View feature lets you view, and adjust the value of,
the currently selected parameter for all of the FX return channels at once.
To activate Parameter View, press F6 (PRM.V) from an FX return channel's main
CH EDIT screen. F6 (PRM.V) is available only when the currently selected parameter
can be displayed in Parameter View.
To return to the main FX return CH EDIT screen, press F6 (CH.V).
If you edit a parameter while in Parameter View, its channel automatically becomes the
currently selected channel.
At the bottom of the Parameter View screen are four tabbed layers on which you'll find
an F button for each of the parameters that can be shown using Parameter View. To
reveal a parameter on a layer that's hidden, press PAGE until the layer appears.
The Aux and FX Send Controls in Parameter View
The Parameter View screen can't fit all FX return channel Aux and FX send controls
onscreen at the same time. You can press
mouse, to scroll through the send control parameters for each of the two Aux and six FX
busses. At the top of the PRM.V section of the display, you'll see the name of the
currently displayed bus.
Roland VS-2000 Owner's Manual
The SENDS Knob switch—When this parameter is checkmarked, it designates the
send to be controlled by the CH PARAMETERS SENDS knob (Page 167). The
VS-2000 remembers the setting for each channel, so whenever you select a channel,
the SENDS knob takes over control of the desired AUX or FX send.
The Send Status parameter—turns the channel's send to the FX or Aux bus on or off.
You can select:
• Off—so that no signal is sent to the Aux or FX bus from the channel.
• Pre or Pst (depending on the Aux or FX bus's current configuration)—to turn on the
send to the Aux or FX bus from the channel.
The Send Level parameter sets the amount of the channel's signal to be sent to the
FX or Aux bus. The range is from -∞ to 6 dB.
Selected channel
and parameter
17—Working with FX Channels
or , or click either arrow with your
www.RolandUS.com 231