Roland VS-2000 Owner's Manual page 7

Emergency Procedures
813
* The following procedures are to be used as
emergency measures only, and are not recommended
for normal operation.
• If the device fails to respond to operational commands or
does not complete operations, turn off the power. If the
power does not shut off following normal shutdown
procedures, disconnect the power plug.
If the unit does not operate normally when the power is
turned on again, it may mean that the hard disk has been
damaged. In such instances, consult your dealer or the
nearest Roland Service Center. Note, however, that it may
not be possible to recover any data from the hard disk
once it has been lost.
If your device features drive check capabilities, use the
drive check function to regularly confirm that there are no
problems, even when the device is operating normally.
For more detailed information on the shutdown and drive
check procedures, refer to the Owner's Manual.
Roland VS-2000 Owner's Manual
Handling the CD-RW Drive
Emergency eject hole
• Install the unit on a solid, level surface in an area free
from vibration.
• Avoid using the unit immediately after it has been moved
to a location with a level of humidity that is greatly
different than its former location. Rapid changes in the
environment can cause condensation to form inside the
drive, which will adversely affect the operation of the
drive and/or damage discs. When the unit has been
moved, allow it to become accustomed to the new
environment (allow a few hours) before operating it.
• It is strictly restricted to eject tray using emergency eject
hall during VS-2000 is operating (while the DISK indicator
of VS-2000 or access indicator of built-in CD-RW drive is
lit).
• Remove any disc from the drive before powering up or
down.
• When you carry VS-2000, remove the disc from the
loading tray.
• To avoid the risk of malfunction and/or damage, insert
only discs with into the CD-RW drive. Never insert
any other type of disc. Avoid getting paper clips, coins, or
any other foreign objects inside the drive.
• Do not touch the lens.
• When the lens is dirty, clean
the lens with a commercial
lens blower.
www.RolandUS.com
Important Notes
Access Indicator
Eject Button
Lens
7