Performing An Auto Punch - Roland VS-2000 Owner's Manual

13—Operating the Hard Disk Recorder

Performing an Auto Punch

1. Set your Auto Punch IN and OUT points as described above.
2. Press A.PUNCH so it's lit.
3. Move to a convenient location in the project before the location you want to punch.
4. Press the track's TRACK/STATUS button so it flashes red.
5. Press REC so it flashes red.
6. Press PLAY.
7. To turn Auto Punch off, press A.PUNCH so it's not lit.
192
When the now line reaches the punch-in point recording automatically begins and
the TRACK/STATUS and REC buttons light solidly red. When the now line gets to
the punch-out point, recording automatically stops and the TRACK/STATUS and
REC buttons resume flashing.
www.Roland.com Roland VS-2000 Owner's Manual