Roland VS-2000 Owner's Manual page 37

6—Track Channel Faders
Use each track channel strip fader to make adjustments to the corresponding track's
output level. Fader 15/16 controls the level of Tracks 15 and 16 as a stereo pair. Fader 17/
18 controls Tracks 17 and 18 together, or can control the level of the Rhythm Track
(Page 305).
When you adjust the linked channel's output level (Page 150, Page 154), move odd-
numbered channel's physical fader.
7—MASTER FADER
The position of the MASTER fader sets the level of the main stereo MASTER mix bus.
Since the MONITOR outputs and the PHONES jacks are typically set to listen to the
MASTER mix bus, the position of the MASTER fader also affects your listening level.
8—EZ ROUTING Button
Press EZ ROUTING to set up, load and save signal routings in the VS-2000:
To learn about
Routing input channels to tracks
Recording tracks onto other tracks
Routing FX return channels to tracks
Activating and de-activating phantom power
Setting up output signals
Sending channels to the internal effects
Saving and loading EZ Routing templates
Clearing routings
Initializing routings
Routing
9—TUNER Button
Press TUNER to turn on the VS-2000's built-in chromatic tuner, described on Page 79.
10—RHYTHM TRACK Button
Press RHYTHM TRACK button to set up and turn on the VS-2000's built-in drum/
percussion pattern generator, described on Page 305.
11—FX 1-6 Buttons
The FX 1-6 buttons allow you to set up and control the VS-2000's effects (AKA, "FX").
The VS-2000 can have up to six effect processors, called "FX 1-6."
•
•
Roland VS-2000 Owner's Manual
To select, set up and edit an effect—press its FX button.
To control the output of an effect processor—press and hold down its FX button to
display the corresponding FX return channel.
see:
Chapter 12
Chapter 14
Chapter 17
Chapter 9
Chapter 21
Chapter 16
Chapter 22
Chapter 22
Chapter 22
www.RolandUS.com
2—Getting Around
37