Roland VS-2000 Owner's Manual page 38

2—Getting Around
As shipped from the factory, Effects 1 and 2 are available. You can add up to four
additional stereo effect processors by purchasing and installing two additional effects
boards—each board adds two stereo effect processors. You can buy and install a:
•
•
For an explanation of the VS-2000's effects, see Chapter 5, starting on Page 87.
When selecting effect patches for Effects 1 or 2—or any processor that's using a VS8F-2
effect board—you can hold down SHIFT and press an FX button to jump to the type of
effect labeled beneath the button.
12—CH EDIT Button
Press the CH EDIT button so it lights, and then press a TRACK.STATUS button to
display the corresponding track channel's settings.
13—LOCATOR•SCENE Button
Press the LOCATOR•SCENE button so it's lit green to store and recall locators using
the TRACK/STATUS buttons. To select a locator bank, hold down LOCATOR•SCENE
when it's lit green and press any TRACK/STATUS button—the display asks you to
select the desired locator bank.
To leave Locator mode, press LOCATOR•SCENE again to unlight the button. Hold
down SHIFT and press the LOCATOR•SCENE button so it's lit red to store and recall
scenes using the TRACK/STATUS buttons. To select a scene bank, hold down SHIFT
and press LOCATOR•SCENE for two seconds—the display asks you to select the
desired scene bank. To leave Scene mode, press LOCATOR•SCENE twice to unlight the
button.
A locator remembers a particular now line position within a project—when you recall
the locator, the now line instantly jumps back to that time position. Each project can
contain up to 96 locators arranged in groups, or "banks," of 16 locators each. Locators
are discussed in detail in "Locators" on Page 182.
A scene stores your current mixer settings, allowing you to save different versions of
your project for instant recall. Each project can contain up to 96 scenes in groups, or
"banks," of 16 scenes each. Scenes are discussed in detail in "Scenes" on Page 142.
14—SOLO•MUTE Button
Press SOLO•MUTE so it's green to enter and exit Solo mode (Page 142). Hold down
SHIFT and press SOLO•MUTE so it's red to enter and exit Mute mode (Page 141).
38
VS8F-2 Effect Expansion Board—to add more effects of the same kind that ship
with the VS-2000.
VS8F-3 Plug-In Effects Expansion Board—to use Roland and third-party plug-in
effects.
www.Roland.com Roland VS-2000 Owner's Manual