Editing A Harmony Sequence; Harmony Snapshots - Roland VS-2000 Owner's Manual

Editing a Harmony Sequence

1. On the HARMONY ALGORITHM VIEW screen, press F5 (MICRO)—the
2. At the bottom of the screen, set TIME to display the project location in:
3. Set LIST to display the type of Harmony data you'd like to see. You can select Note,
4. To display the source track's waveform, press F1 (WAVE) so its darkened.
5. Set Solo to:
6. To edit an already sequenced note, turn the TIME/VALUE dial to highlight it in the
7. Press
For a note in the list, Val1 is the note number and Val2 its velocity, or the force with
which the note plays.
8. To preview the selected event, press F2 (LISTEN).
9. To add a new event, set the CREATE parameter to the type of event you'd like to
10. To erase the selected event, press F4 (DELETE).
11. To reverse your last edit, press F5 (UNDO). To change your mind, press F5 (REDO).

Harmony Snapshots

You can easily take "Harmony snapshots" of important current Harmony module
settings at the now line's current location. When the project plays, the settings are
applied, changing the Harmony sound at that location in the project. You can capture
the following current settings individually:
•
•
Roland VS-2000 Owner's Manual
HARMONY MICRO EDIT screen appears.
On this screen, you can edit your Harmony sequence in detail.
• TIME—so Harmony events are identified by their clock-time location in the
project.
• MBT—so Harmony events are identified by their "Measure, Beat and Tick"
location.
PBend (for "Pitch Bend"), VbSw (for "Vibrato Switch"), VbRt (for "Vibrato Rate"),
VbDt (for "Vibrato Detune"), VbDp (for "Vibrato Depth"), VbDl (for "Vibrato
Delay"), PtSw (for "Part Switch"), PtTm (for "Part Time"), Frm1-6 (for "Formant 1-6")
and/or All. To display an item select it and press ENTER/YES to checkmark it.
• Off—all channels play normally.
• On—only the harmonies and source track are heard.
event list at the top of the screen and press ENTER/YES.
or to highlight the setting you wish to change, and turn the Time/Value
dial to select the desired value.
add, and then press F3 (CREATE). Edit the new event as desired.
Portamento switch and time
Formant settings 1-6
• Vibrato switch, rate, detune, depth and delay
www.RolandUS.com
25—Harmony
Event list
The selected data
appears here, along with
the source track's
waveform when WAVE is
turned on. For enhanced
responsiveness, leave
WAVE turned off.
339