Resetting Mixer Parameters; Storing A Scene In Safe Mode; Clearing A Scene In Safe Mode - Roland VS-2000 Owner's Manual

10—Using the Digital Mixer

Storing a Scene in Safe Mode

1. Hold down SHIFT and press LOCATOR•SCENE—the
2. Turn the Time/Value dial to scroll through the list until
3. Enter the memory location's two-digit number on the
4. Press ENTER/YES to store your current mixer settings in the selected scene

Clearing a Scene in Safe Mode

1. Press SCENE—the SCENE window appears.
2. Turn the Time/Value dial to scroll through the list until
3. Enter the scene's two-digit number on the numeric
4. Press CLEAR—"Clear Scene?" appears.
5. Press ENTER/YES to clear the selected scene and close the window, or just press

Resetting Mixer Parameters

You can quickly reset most mixer parameters to their default values should you wish to
start over with a "clean slate." To do this:
1. Hold down SHIFT and press F4.
2. Press PAGE until "PrmIni" appears above F1.
3. Press F1 (PrmIni).
4. Turn the Time/Value dial to select MIXER.
5. Press F5 (OK)—a confirmation screen appears.
6. If you're sure you want to proceed, press ENTER/YES. To cancel the operation,
The reset procedure does not initialize all of the mixer's settings. For example, it
doesn't delete your scenes, or reset the LOCATOR/SCENE TYPE parameter described
on Page 145.
146
SCENE window appears.
the desired unused scene memory location is visible.
numeric keypad—an arrow appears to the left of the
scene in the list and "Save Scene?" appears in the
window.
memory location and close the window, or just press EXIT/NO twice to leave the
window without saving the scene.
the desired scene is visible.
keypad—an arrow appears to the left of the scene in
the list.
EXIT/NO three times to leave the window without clearing the scene.
press EXIT/NO.
www.Roland.com Roland VS-2000 Owner's Manual