Roland VS-2000 Owner's Manual page 162

11—Input and Track Channel Tools
1. EQ Sw
The EQ Sw ("EQ Switch") parameter turns the CH EDIT EQ on and off.
2. ATT
The EQ screen provides easy access to the ATT parameter that also appears
on the CH EDIT VIEW screen. See Page 151.
3. EQ Meters
There are two meters on the EQ screen:
•
•
4. Interactive EQ Display
The interactive EQ display shows you the settings of the four EQs. Each equalizer is
represented by a triangle.
You can change a band's gain and frequency values on the interactive EQ display with
your mouse by dragging its triangle:
•
•
5. Low Band EQ
The Low EQ band operates on all frequencies below the selected
frequency. It has a:
•
•
The low band EQ is a shelving-type EQ that affects the level of all frequencies below
the selected frequency, as well as a narrow range of frequencies slightly above it. As
such, it requires no Q setting.
162
The IN meter shows you the level of the signal as it enters the EQ screen.
The OUT meter shows you the signal's level as it leaves the EQ screen.
Low band
left or right to lower or raise, respectively, change its frequency.
down or up to lower or raise, respectively, its gain.
frequency selector—that sets the center frequency, from 20 Hz to 1.00 kHz.
gain control—that raises or lowers the level of the selected frequency range. It can
be set anywhere from -15.0 dB to 15 dB.
www.Roland.com
Lo-Mid band Hi-Mid band
Frequency
High band
The dotted vertical
lines help you see
where you are as
you drag a triangle.
Roland VS-2000 Owner's Manual