Turning Off The Vs-2000 - Roland VS-2000 Owner's Manual

Turning Off the VS-2000

It's important the you don't simply flip the VS-2000's POWER switch to turn it off—
always use the procedure below to prevent damage to your data.
If you'd like to restart the VS-2000—perhaps while troubleshooting a problem—use the
procedure below as well.
Turning Off the VS-2000
1. Hold down SHUTDOWN for two seconds. The following dialog appears:
2. If you wish to turn off or restart the VS-2000, press ENTER/YES. If not, press
3. If you've made changes to the currently loaded project you'd like to preserve, press
If you're shutting down the VS-2000 when a factory demo song—or any other protected
project—is loaded, you won't be prompted to store the current song.
4. If you'd like to restart the VS-2000, hold down SHIFT and press the flashing PLAY
If you need to move the VS-2000 after shutting it down, wait 30 seconds or so to give its
hard drive a chance to stop spinning in order to avoid damaging it.
Roland VS-2000 Owner's Manual
EXIT/NO to cancel the operation. If you press ENTER/YES, a dialog like this one
appears:
ENTER/YES. If you haven't, press EXIT/NO.
In either case, the VS-2000 takes a few moments to prepare to shut down—and to
save your project if you pressed ENTER/YES in Step 3. When the VS-2000 is ready
to be powered off, the following message appears:
button—the VS-2000 begins its power-up sequence. If you'd like to shut down the
VS-2000, flip its rear-panel POWER switch to its Off position.
4—Setting Up and Basic Operations
The name of the
currently loaded project.
The project's sample rate and
recording mode (Page 102).
www.RolandUS.com 85