Ch Parameters Controls; Using The Ch Parameters Knobs - Roland VS-2000 Owner's Manual

CH PARAMETERS Controls

The CH PARAMETERS area of the VS-2000's front panel provides a fast way to adjust
important settings for the currently selected channel while the channel's CH EDIT
parameters are being displayed. Using the CH PARAMETERS controls, you can adjust:
•
•
•
•
The upper four CH PARAMETERS knobs can control the channel's dynamics processor
or EQ, but not at the same moment. Their behavior is determined by the DYNAMICS
and 4 BAND EQ button. Press either button to assign the knobs to the desired job.

Using the CH PARAMETERS Knobs

1. Display the desired channel's CH EDIT parameters.
2. To adjust the channel's:
When you press the CH PARAMETERS DYNAMICS and 4 BAND EQ buttons, the
VS-2000 jumps to the selected channel's CH EDIT VIEW screen for your convenience.
Roland VS-2000 Owner's Manual
four of the channel's DYN parameters (Page 158).
the channel's EQ gain parameters (Page 162).
the amount of the channel's signal going to the currently designated Aux or FX bus
(Page 150).
the panning of the channel's signal in the stereo MASTER mix, or the amount of
the channel's signal going to the RSS Pan effect if it's assigned to RSS Pan
(Page 155).
• DYN parameters—press DYNAMICS so it lights and use the top four CH
PARAMETERS knobs as THRESHOLD, ATTACK, RELEASE and LEVEL knobs.
• EQ parameters—press 4 BAND EQ so it lights and use the top four CH
PARAMETERS knobs as LOW G, LO-MID G, HI-MID G and HIGH G knobs.
If you turn the knobs while you are holding 4 BAND EQ down, you can change
value of frequency.
• Designated Aux or FX send—turn the SENDS knob as desired.
• RSS Pan amount or stereo panning—turn the RSS/PAN knob as desired. If the
channel's sending signal to the RSS Pan effect, the knob controls the amount of
its signal being sent to the effect. If the channel's not going to the RSS Pan
effect, the knob adjusts the channel's signal in the stereo MASTER mix.
11—Input and Track Channel Tools
www.RolandUS.com 167