Playing Multiple Parts (Multi Part Play); Viewing The Part Settings (Part View Screen) - Roland FA-07 Reference Manual

Playing Multiple Parts (Multi Part Play)

If you want to perform using three or more parts in a complex
combination, or if you're using the sequencer to create a song,
you'll use all 16 parts of the studio set (multi part play).
1.
Press the [SPLIT] button and
simultaneously .
[SPLIT] [DUAL]
The button and
multi part play mode.
If you press the [SPLIT] button and
once again, you return to single play mode.
About the screen
10
1
3
2 5
No . Explanation
1 Bank, number, and name of the studio set
2
Part number
3 Type and bank of tone
4 Tone number and name
5
Category name and lock
6 Keyboard status (key range, etc.)
7 Tone level
8 Keyboard switch setting
9 Arpeggio switch setting
10 Effect information and status
11 Song information
MEMO
• To edit a setting, move the cursor to that value and turn the dial.
If you want to keep the edited settings, save the studio set in the
user bank (p. 45).
• To change the keyboard range, move the cursor to the keyboard
( 6 ) and turn the dial, or press a key while holding down the
[SHIFT]
button.
•
To view all parts simultaneously, hold down the
and press the [7] (
26
[DUAL] button
button are both lit, and the FA is in
[DUAL] button simultaneously
11
8
7
4
6
Page
[SHIFT]
button
) button.
Viewing the Part Settings (PART VIEW
Screen)
In the PART VIEW screen you can view or edit a list of the part
settings.
1.
Press the
2.
Move the cursor to
button .
The PART VIEW screen appears.
MEMO
You can also access the PART VIEW screen from the STUDIO SET
9
PLAY screen by holding down the
[4] (Part View)
the
3.
Use the cursor buttons to select a parameter, and use the
dial to edit the value .
You can switch tabs by holding down the
the cursor [
MEMO
For more about the part parameters, refer to
Guide"
p. 27
–
p. 11
–
–
p. 44
p. 44
p. 27
p. 32
p. 52
p. 56
[MENU] button .
"Part View" and press the
[SHIFT]
button.
[SHIFT]
] [ ] buttons.
(PDF).
[ENTER]
button and pressing
button and using
"Parameter