Figure 102 Connection Example With A Dedicated Remote Support Port; Figure 103 Connection Example When The Ip Address Of The Slave Cm Is Set (And A Dedicated Remote Support Port Is Used) - Fujitsu ETERNUS DX S5 Series Design Manual

5. Connection Configuration
LAN Connection
Figure 102 Connection Example with a Dedicated Remote Support Port
Administration
terminal
LAN switch
IP address C IP address A
Different LANs are used for MNT ports and RMT ports.
Note
The following figure provides connection examples and explains the necessary preparation for when the IP
address of the Slave CM is set.
For the ETERNUS DX, three IP addresses are required (two IP addresses for the MNT ports and one IP
address for the RMT port).
Figure 103
Support Port Is Used)
Administration
terminal
IP address C
Different LANs are used for MNT ports and RMT ports.
The IP addresses of the Master CM and the Slave CM are set.
SNMP
E-mail server
manager
Syslog server
CM#0 CM#1
Controller enclosure
ETERNUS DX
Connection Example When the IP Address of the Slave CM Is Set (and a Dedicated Remote
SNMP
E-mail server
manager
Syslog server
LAN switch
LAN for operation management
IP address A IP address B
CM#0 CM#1
Controller enclosure
ETERNUS DX
NTP server
Authentication
server
LAN for operation management
Router
Remote support
center
NTP server
Authentication
server
Router
Remote support
center
205 Design Guide