Table of Contents
Advertisement
Subscriber Database
The Subscriber Database
contains the information on the
transmitters that are assigned in
the system. See the "Security
Escort Operations Manual".
When the Advanced button is
pressed in the Subscriber
Database Edit dialog the
following Edit Subscriber
Advanced Features dialog will
be displayed.
The "Edit Advanced Subscriber
Features" dialog is used to set
up special transmitters that
monitor fixed locations,,
subscriber pager access,
parameters for point
transmitters, the virtual fence for
a Wandering Alarm, the alarm
group for arming of the
transmitter and check-in
requirements for this transmitter.
Phone Number
Pager Password
Pager ID
Pager Group
Pager Confirmation Not
Required
Fixed Location Transmitter
Floor Level
Map X Position
Map Y Position
Figure 31: Subscriber Advanced Features Dialog
This phone number is dialed to send a pager message to this subscriber.
Typically this is a different phone number than the one that is manually dialed
to access this pager. The phone number is assigned by the paging service.
This is the password to be sent to the paging service when a page is sent to
this subscriber. Leave blank if not required (typically the Pager Password is
not required). The Pager Password is assigned by the paging service.
This is the ID that identifies the pager to receive the pager message (many
times this value is the last 7 digits that would be manually dialed to access
this pager). The Pager ID is assigned by the paging service.
These are the pager groups that this subscriber is a member of. This
subscriber may be a member of up to 3 different pager groups.
If checked, the confirmation pager message is not sent to this pager if alarm
is acknowledged by an acknowledgement transmitter.
This section is to be used only when this transmitter is mounted in a fixed
location (it does not move). When this transmitter transmits and alarm it will
always be reported at the programmed location.
This is the floor level where this alarm is to be located for a fixed location
transmitter.
This is the X coordinate of the map position where this alarm is to be located
for a fixed location transmitter.
This is the Y coordinate of the map position where this alarm is to be located
for a fixed location transmitter.
Security Escort Training
Page 89 of 142
Advertisement
Table of Contents
