Table of Contents
Advertisement
"Off"
When clicked, the checked Horn-Siren, Green LED and Red LED - Strobe outputs will be turned off for the
selected point on the selected transponder. If the output does not change, click "On" then click "Off" again.
"On"
When clicked, the checked Horn-Siren, Green LED and Red LED - Strobe outputs will be turned on for the
selected point on the selected transponder. If the output does not change, click "Off" then click "On" again.
"Ambient"
The Ambient value is shown above "Auto Advance", it displays the current ambient level at the receiver. To get
an updated ambient reading, select the point, click the Transmit button, then click the Ambient button.
"RF Micro Version"
The receiver's RF micro revision level is shown below "Auto Advance". To get an updated reading click the
Revision button.
"Antenna"
Normally a receiver automatically switches between its diversity antennas during normal operation (the default
selection, a working system should be left at this setting). The receiver can be forced to use only the left or right
antenna or always switch by selecting the appropriate setting and clicking the "Antenna" button.
"Ant Map"
Clicking "Ant Map" will cause the system to interrogate the current antenna switching settings of all receivers on
this transponder.
"Transmit"
Clicking "Transmit" will cause this receiver to send one test transmission.
"Reset Point"
Clicking "Reset Point" will cause the microprocessors on this point to reset as if they were just powered up. A
Receiver should not be reset in a working system, as it can cause receptions to be lost.
"Ambient"
Clicking "Ambient" will cause the system to interrogate the current ambient levels of all receivers on this
transponder.
"Revision"
Clicking "Revision" will cause the system to interrogate the RF micro revision levels of all receivers on this
transponder.
"Jamming"
A receiver monitors the ambient level during normal operation. If the ambient level rises above the jamming
setting and Jamming trouble is reported to the Central Console. The receiver's jamming level can be adjusted by
selecting the appropriate setting (shown in hexadecimal levels) and clicking the "Jamming" button.
"Jam Map"
Clicking "Jam Map" will cause the system to interrogate the jamming setting levels of all receivers on this
transponder.
Security Escort Training
Page 124 of 142
Advertisement
Table of Contents
